Insulation Company in Sedco Hills, CA
Blown in insulation is the workhorse fix for most Sedco Hills attics, because the housing stock here runs older, irregular, and under-insulated from the day the homes went up. We’re Maple Insulation Co, and we’ve served Sedco Hills since 2017. The defining local problem is inland heat: attics above Lake Elsinore’s basin climb past 140°F in summer, and settled or thin insulation lets that heat radiate straight down into living rooms all afternoon. Call us at (855) 341-6045 for a free estimate on blown in cellulose or fiberglass, attic retrofits, spray foam, or any combination that matches your home’s construction.
Why Sedco Hills Homes Are Different
Sedco Hills is an unincorporated Riverside County community perched on canyon-and-ridge terrain above the Lake Elsinore basin. Summer temperatures routinely push past 100°F, and the problem isn’t winter cold – it’s brutal afternoon heat gain that soaks through the roof deck and turns attics into ovens. Homes here range from 1970s and 1980s site-built houses to manufactured and mobile homes on large rural lots, and many of them have original insulation that has settled to a fraction of its rated depth. We regularly find attics in Sedco Hills with three or four inches of matted fiberglass where code now calls for far more, plus gable vents that simply aren’t moving enough air. Retrofitting means working around irregular truss spacing, low-slope roof sections, and cramped attic access points that were never designed for modern insulation equipment. Sedco Hills being unincorporated means Riverside County building standards apply, and we handle the paperwork side so you don’t have to guess at what’s required.
Our Main Sedco Hills Services
Two services drive most of our work in Sedco Hills: attic insulation retrofits for older homes, and spray foam for the irregular cavities and hard-to-reach areas common in rural builds and mobile homes.
Attic Insulation in Sedco Hills
Most Sedco Hills attics we inspect fall well short of what the inland climate demands. Hot attic air cooks the living space below when insulation is thin, settled, or full of gaps around can lights and access hatches. We remove or top up the existing material, air-seal the attic floor, and blow in fresh coverage to a depth that actually works for this heat. For homes with poor ventilation, we often recommend adding a radiant barrier to reflect solar gain before it ever reaches the insulation. Attic Insulation in Sedco Hills is a page we built specifically for this work.

Spray Foam Insulation in Sedco Hills
Sedco Hills has a lot of homes with odd wall assemblies, rim joists that leak air, and crawlspaces or underpinning areas that batts and blown material can’t reach properly. Spray foam solves those spots in one pass. We install both Icynene open-cell and Demilec closed-cell products, so we can match the foam to the moisture conditions and budget of the job instead of forcing one product onto every situation. Spray Foam Insulation in Sedco Hills covers the full breakdown of when foam is the right call.

What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Blown In Insulation in Sedco Hills

Blown in insulation is the most common retrofit we perform in Sedco Hills, because it’s the fastest way to get a settled, under-insulated attic back to a level that actually blocks summer heat. Homes here from the 1970s, 1980s, and the area’s many manufactured units rarely came with enough attic coverage, and what’s there has compacted over decades of hot, dry conditions. Blowing in cellulose or fiberglass lets us fill the entire attic floor evenly, including the odd nooks and shallow cavities around trusses that batts can’t cover. For a deeper look at the method itself, see our Blown In Insulation hub page. The work we do in Sedco Hills usually takes one day, and it changes the indoor temperature the same afternoon.
Cellulose Insulation
Signs you need it
Your upstairs rooms stay hot well into the evening even after the sun goes down, and your attic shows dark, settled patches where old insulation has compressed to almost nothing.
What it costs in Sedco Hills
Blown in cellulose in Sedco Hills typically lands between $0.90 and $1.50 per square foot of attic floor, depending on depth and access.
How we do it
We air-seal the attic floor penetrations first, then blow GreenFiber cellulose to a consistent depth with a calibrated machine, working around ducts and framing so coverage is uniform.
Blown In Attic Insulation
Signs you need it
Rooms directly under the attic feel noticeably warmer than the rest of the house by mid-afternoon, and you can see the tops of ceiling joists poking through the existing insulation.
What it costs in Sedco Hills
A full blown in attic insulation job in Sedco Hills generally runs $1,200 to $2,800 for a typical single-story home, before any venting or radiant barrier add-ons.
How we do it
After checking the existing depth and identifying air leaks, we blow fresh material across the entire attic floor to a target depth, then verify coverage with depth markers in multiple spots.
Loose Fill Insulation
Signs you need it
Your energy bills spike every summer, and the attic has low spots or bare patches where wind, pests, or old wiring work have displaced the original material.
What it costs in Sedco Hills
Loose fill insulation for a Sedco Hills attic typically costs between $1.00 and $2.00 per square foot installed, with access difficulty being the biggest variable.
How we do it
We use a high-volume blower to distribute the loose material evenly, starting at the farthest eaves and working back toward the access point so we never walk down the fresh coverage.
What Blown In Insulation Costs in Sedco Hills
| Item | Typical range in Sedco Hills |
|---|---|
| Blown in cellulose insulation | $0.90 – $1.50 per sq ft |
| Blown in attic insulation (full job) | $1,200 – $2,800 |
| Loose fill insulation | $1.00 – $2.00 per sq ft |
How long does blown in insulation last in Sedco Hills?
Cellulose holds its depth well and can last 20 to 30 years, but Sedco Hills heat and occasional roof leaks can shorten that, so we check existing material before topping up rather than assuming the old stuff is fine.
Can you blow insulation into a mobile home attic in Sedco Hills?
Yes, most manufactured homes here have shallow attics that take blown in material well, though we work carefully around the tighter roof pitch and verify the ceiling can handle the added weight. Call (855) 341-6045 and we’ll take a look.
Brands We Service in Sedco Hills
We install GreenFiber cellulose, Owens Corning fiberglass, and both Icynene and Demilec spray foam products in Sedco Hills. Because we carry insulation from eight manufacturers across every major material category, we don’t have to talk you into a product that doesn’t fit your roof, your walls, or your budget. Most materials for Sedco Hills jobs are staged at our Cypress yard within a day or two. See our brands for the full roster.
Pricing for Insulation Company in Sedco Hills, CA
| Service | Typical range in Sedco Hills |
|---|---|
| Blown in cellulose insulation | $0.90 – $1.50 per sq ft |
| Blown in attic insulation (full job) | $1,200 – $2,800 |
| Loose fill insulation | $1.00 – $2.00 per sq ft |
| Attic insulation retrofit | $1,500 – $3,500 |
| Spray foam insulation (open-cell) | $1.50 – $3.00 per sq ft |
| Spray foam insulation (closed-cell) | $2.50 – $5.00 per sq ft |
| Radiant barrier installation | $800 – $2,500 |
| Attic air sealing | $400 – $1,200 |
Sedco Hills pricing runs higher when we’re working around low attic clearance, steep lots with difficult truck access, or homes that need old material removed before we can start. We give you a fixed price before any work begins, and that number doesn’t move unless the scope changes and you approve it first.
Neighborhoods We Serve in Sedco Hills
Sedco Hills spans steep streets and winding lots across the hills above Lake Elsinore, and we work the entire 92531 ZIP. Many homes sit well back from the road or up long driveways, so we schedule our trucks accordingly.
- Sedco Hills proper
- Riverside Drive corridor
- Grand Avenue hillside
- Lakeland Village boundary area
- North Lake Elsinore rural lots
For most Sedco Hills locations we can have a crew on site within two to three business days, and same-week appointments are common during the spring and fall retrofit seasons.
Service Area – Cities Near Sedco Hills
Besides our regular work in Sedco Hills, we cover neighboring Riverside County communities around Lake Elsinore. If you’re in Lakeland Village, CA, Canyon Lake, CA, Meadowbrook, CA, or Quail Valley, CA, give us a call at (855) 341-6045 – we run crews through these areas every week.
Serving Sedco Hills, CA — Our Local Coverage Area
We’re based in the Sedco Hills area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Insulation Company in Sedco Hills
Most insulation retrofits in unincorporated Riverside County don’t require a permit, but if your job does – for example, when structural work or new venting is involved – we prepare and file the paperwork. We’ll tell you upfront whether your project needs anything.
We typically reach Sedco Hills homes within two to three business days for estimates, and installations run the same week in most cases. Emergency calls for severe heat or damaged insulation get prioritized whenever possible.
Yes, a large share of our Sedco Hills work is on manufactured and mobile homes. Their attic spaces are tighter and the ceiling assemblies are lighter, so we adjust the material and depth accordingly. Call (855) 341-6045 and we’ll set up a free estimate.
What happens when you call
- 1A real person answersNo phone trees — talk to a local insulation pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3A background-checked tech heads outLicensed & insured, typically within the hour.
- 4You approve before work beginsNothing starts until you say go.
What Sedco Hills Customers Say
"Installed baffles at the soffits so the new insulation didn't block the ventilation, which the previous contractor apparently never considered."
— Eric Fletcher"Spray foam in the rim joists in the basement. The cold floors above them are gone."
— Kelly Meyer"He did a blower door test before and after and gave me the numbers. I like being able to see the difference rather than being told about it."
— Ruben Guzman